Specification:

Rated Voltage: DC 12V

Rated Power: 60W

Maximum Flow: 5L/min

Maximum Pressure: 0.8MPA

Pump Diameter: Approx. 4.8cm / 1.89inch

Length: Approx. 14.5cm / 5.7inch

Cable Length: Approx. 30cm / 11.8inch

Clips Length: Approx. 8cm / 3.15inch

Outlet PVC pipe Length:150cm

Nylon pipe Length:100cm

Color:as picture show

Features:

100% brand new and high quality

Widely used in general industrial equipment, medical equipment, chemical equipment, shipbuilding, drinks, carpet and floor cleaning, water purification and water treatment equipment, vehicle cleaning, agricultural spraying, zo pipeline pressure, air cleaning cooling, coal and metallurgical industries

The advantage of the plastic tube relative to the copper tube is that it is more resistant to high temperatures and has high applicability.

Note: If you want to connect this pump to AC power, you will need a power converter

Using Method:

Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil

Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal

Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move

Put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely.As no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)

After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean

If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out

Package List:

1x Oil Pump

1x 11mm Outlet PVC pipe

1x 6mm Nylon pipe