Made in the USA To the highest quality, dont be fooled by the competition that makes everything in China!
the Chinese have copied my products with the worst quality!
... take a moment and look carefully at the quality (the photos speak
for themselves)
see the comments of my 100% satisfied clients...More than 10 years in the
manufacture of these exhausts from Florida USA.
Engine not included.
You can put a 3/4 pipe line buying at home depot to get the engine gases out of your garage or any other closed places. Threaded 3/4 NPT Exhaust Flange.
2 Lock washer and 2 nut included.
Gasket.
1/4" thick flange, heavy duty! 3/4" Male Thread Pipe Fitting Single Male Stainless Steel 304 NPT Tig welded. Good for: Mini bikes, go karts, generators... multipurpose.
Fit in the following engines: Predator 212cc (6.5hp) Predator Hemi Engine from harbor freight. Honda GX160, GX200. Powerhorse 208cc, DuroMax XP7HPE 7 Hp... and many other clones, please check the measurements of your engine before you buy. center hollow to hollow 1"13\16 (see photos for details)
*INTERNATIONAL CAN TAKE 30 DAYS! Made in U.S.A. We only ship to paypal confirmed address.
Florida residents pay 7% taxes.
Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry
standard for the sizes of pipe is not always as straight-forward as
measuring the pipe. Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is
measured and based on the inside of the pipe. But, to actually determine
the size of a pipe, the outside diameter of each pipe or fitting must
be measured and compared to the table for size identification. For
example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches.
Each thread size has a defined number of threads per inch (TPI). The
3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per
inch) and OD (outside diameter) of the thread are required for positive
identification of thread size because several sizes have the same TPI.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Please check my other Header (on other audition)